Protecting your plumbing from frost
In short
Before the frost, three precautions limit the damage: know how to turn off the water (a working stop valve), protect the water meter and pipes in unheated spaces from the cold, and drain outdoor taps. If a pipe freezes, turn off the water and thaw it gently, never with a flame. If it has burst, turn off the water and call a plumber.
What should you protect before the cold arrives?
This advice comes from the water companies CILE, VIVAQUA and De Watergroep:
- The stop valve: check that it works properly. It is what turns off the water if there is a leak.
- The water meter: protect it from draughts and, if possible, keep the temperature around the meter and pipes above 0 °C. If the meter is outdoors, insulate its surroundings carefully while keeping it easy to reach.
- Exposed pipes: insulate pipes in unheated, cold or poorly insulated spaces before the cold spell starts.
- Outdoor taps: drain outdoor taps and pipework.
- Nights of hard frost: VIVAQUA advises leaving the tap furthest from the meter running slightly.
- Long absences: drain the pipes you do not use, after turning off the water at the meter.
A pipe has frozen: what should you do?
If no water comes out in freezing weather, a pipe may have frozen. De Watergroep and CILE advise:
- Close the main valve.
- Thaw gradually with a hair dryer, starting from the main valve side.
- Never use a flame or a heat gun: plastic pipes in particular can melt.
- Once the pipes have thawed, open the main valve slightly and watch: if you notice a leak, close it again at once and contact a plumber.
Has the water meter itself frozen? Contact your water company.
A pipe has burst: what are the right reflexes?
- Turn off the water immediately: close the stop valve located before the meter.
- Do not thaw a burst pipe before the plumber who will repair it arrives.
- Call a plumber to repair pipes after the meter; for a leak at the meter or the main valve, contact your water company.
When should you call a plumber?
As soon as a pipe has burst, a leak appears after thawing, or the frozen pipe is hard to reach: De Watergroep advises against DIY and recommends contacting a plumber. Think about the boiler too: according to Vaillant, a condensing boiler can stop because of a frozen condensate pipe.
For a pipe to repair or insulate, see our plumbing page. If your boiler has stopped in the cold, our boiler and heating page presents our repair service.
Frequently asked questions
How do you thaw a frozen water pipe?
First close the main valve, then warm the pipe gradually with a hair dryer, starting from the main valve side. Never use a flame or a heat gun, especially on plastic pipes. If the pipe has burst, wait for the plumber before thawing it.
What should you do if a pipe bursts?
Immediately close the stop valve located before the water meter, then call a plumber to repair the pipes after the meter. Do not thaw a burst pipe before the plumber arrives.
Sources
- Votre compteur d'eau : attention au gel ! (CILE, 5 November 2026, in French) (checked on )
- Nos FAQ les plus consultées: frost and leaks (VIVAQUA, in French) (checked on )
- Wintertips (De Watergroep, in Dutch) (checked on )
- Rallumer une chaudière au gaz en toute sécurité (Vaillant Belgium help centre, in French) (checked on )